Engine-Transmission rebuilding

NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.

Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.

If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here

Topics	Statistics	Last Post
flywheel truing by cscott Started by cscott, 08-09-2022, 06:22 AM	11 responses 381 views 0 likes	Last Post by cscott 08-12-2022, 11:11 AM
3 Speed w/ Reverse by JSB55 Started by JSB55, 07-17-2022, 04:22 PM	24 responses 672 views 0 likes	Last Post by JSB55 08-04-2022, 09:46 AM
Early 45 3 speed transmission help by montij Started by montij, 07-29-2022, 10:12 PM	4 responses 142 views 0 likes	Last Post by montij 07-30-2022, 04:05 PM
45 Engine Rebuild, Could Use Some Guidance by Rex Started by Rex, 07-20-2022, 08:42 PM	6 responses 252 views 0 likes	Last Post by T. Cotten 07-24-2022, 09:46 AM
4 speed Sprocket nut torque, Spacer Key, and Shift Fork spacing by JSB55 Started by JSB55, 07-10-2022, 12:40 PM	13 responses 286 views 0 likes	Last Post by JSB55 07-13-2022, 07:41 PM
1917 thor by 34VLRay Started by 34VLRay, 07-05-2022, 05:42 AM	2 responses 122 views 0 likes	Last Post by 34VLRay 07-05-2022, 08:45 AM
roller cage drive shaft, pinon shaft by cscott Started by cscott, 06-18-2022, 12:40 PM	1 response 123 views 0 likes	Last Post by Rubone 06-18-2022, 02:50 PM
45 Valve Spring Length by Rex Started by Rex, 04-25-2022, 08:05 AM	3 responses 132 views 0 likes	Last Post by T. Cotten 04-26-2022, 11:15 AM
45 41-73 Transmission Rebuild by Rex Started by Rex, 01-17-2022, 05:00 PM	8 responses 527 views 0 likes	Last Post by Rex 04-25-2022, 07:56 AM
Indian piston fit by exeric Started by exeric, 12-17-2021, 03:50 PM	10 responses 415 views 0 likes	Last Post by PRG 12-28-2021, 10:10 AM