Factory H-D Tools

[Rubone]

Rubone, when you say 30's up style for the crank jig, does that mean that the JD cranks do not fit in that style. I am looking to but a truing jig for JD's, and want to make sure I get the correct one.

They will fit fine, I am just referring to the time frame it was produced for, there are a couple earlier versions that do not do the later cranks due to width constraints.

[aumick10]

Thanks, I have 4 motors to build for myself. You interested in selling that one? Cheers

[Rubone]

45 clutch tool, works on both '40 and earlier and '41 up clutches to remove lock nuts (and adjust spring pack spacing on the early one) DCP_3959.JPG .

[1937hd]

Panhead tool.

[1937hd]

20201213_123223.jpg20201213_181003.jpg

[Architect]

Hey Robbie, did the MoCo have a tool for Shovelhead/Ironhead rocker shaft end caps with the slot? You got a picture of one??

[41craig]

Panhead tool.

I have the tool that you are displaying, but mine has the spring and rubber bushing that is shown in the catalog. My question is what is the purpose of the spring and bushing? It's easy to figure what to do with the tool itself.
Craig

CIMG1927.JPGCIMG1928.JPGCIMG1966.JPG

[Rubone]

'41 up 45 clutch hub nut wrench
DCP_3960.JPG

[Rubone]

Piston pin lock ring tool for "L" section lock rings
DCP_3984.JPG

[Rubone]

Piston pin lock ring tool for spiral locks. DCP_3553.JPG

[Rubone]

BT mainshaft starter clutch and bearing puller
DCP_3951.JPG

[41craig]

Ignition Timing Gage 95882-63 for gaging top dead center. CIMG1929.JPGCIMG1930.JPG

[41craig]

Inlet Housing Nut and Crank Case Bolt Wrench 11903-X for 1929 and earlier big twins. CIMG1944.JPGCIMG1945.JPGCIMG1946.JPG

[Rubone]

Crankpin and shaft nut wrenches assorted sizes.
DCP_3990.JPG

[41craig]

Piston Pin Pusher Tool 11910-X ( missing the handle, guide pin, and pusher collar. CIMG1954.JPGCIMG1955.JPGCIMG1969.JPG