Now on to more work on the soon to be 1936 springer. This is a before shot of the upper spring perch.

I welded both of the side grease zerk holes shut using a wirefeed welder.

Then I roughed it in carefully using is hand dremel.




Jerry
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here





Leave a comment: