Factory H-D Tools

[Rubone]

'41 up 45 transmission mainseal removing and installing tool
DCP_3958.JPG

[Rubone]

[QUOTE=41craig;n278858]

Sidevalve valve spring compressor.
Robbie maybe you missed my question. Did you or the previous owner bend down the ends of the fork or is this a later upgrade to the valve spring compressor ?

Craig

I have two of them and they were both that way when I got them in the '70s. Not sure if it was factory or dealer done.

[41craig]

This is a facer for crank case bronze bushings 1929 and earlier Big Twins. It's used to face off the thick shoulder of the gear side crank case bushing after it has been pressed into case. Part # 11939-X The cutter on the tool was replaceable with Part # 11940-X.
Craig
CIMG1948.JPGCIMG1949.JPGCIMG1950.JPG

[41craig]

[QUOTE=Rubone;n278737]Sidevalve valve spring compressor.
Robbie maybe you missed my question. Did you or the previous owner bend down the ends of the fork or is this a later upgrade to the valve spring compressor ?

Craig

[painterdale]

Very interesting!
Thanks, Robbie!

Dale

[Rubone]

JD lathe plate.jpg

[painterdale]

I plead ignorance!
What's the JD tool used for?

Dale

[Rubone]

DCP_2568.JPGDCP_2569.JPGDCP_2570.JPG Hydra-Glide fork bushing tools...

[1937hd]

Not at this time.Just nice to have in case I need it.

[MMasa]

1937HD
you want to sell that JD tool?
mark

[1937hd]

Here is a nice jd tool. 20201204_175759.jpg

[1937hd]

[Rubone]

Since Servi-Car wheel pullers were recently discussed here are two, the larger diameter for '32-'36, the smaller for '37-'50. The '51 and later juice wheels use a standard automotive type. DCP_3963.JPG

[41craig]

These are the taps for the intake nipples on Big Twin OHV 61" Knuckleheads and 74" Knucklehead and Panhead models. CIMG1920.JPGCIMG1921.JPGCIMG1923.JPG Craig

[41craig]

This is the springer handlebar end tap. CIMG1925.JPGCIMG1926.JPG Craig