Factory H-D Tools

[Rubone]

BT mainshaft starter clutch and bearing puller
DCP_3951.JPG

[Rubone]

Piston pin lock ring tool for spiral locks. DCP_3553.JPG

[Rubone]

Piston pin lock ring tool for "L" section lock rings
DCP_3984.JPG

[Rubone]

'41 up 45 clutch hub nut wrench
DCP_3960.JPG

[41craig]

Panhead tool.

I have the tool that you are displaying, but mine has the spring and rubber bushing that is shown in the catalog. My question is what is the purpose of the spring and bushing? It's easy to figure what to do with the tool itself.
Craig

CIMG1927.JPGCIMG1928.JPGCIMG1966.JPG

[Architect]

Hey Robbie, did the MoCo have a tool for Shovelhead/Ironhead rocker shaft end caps with the slot? You got a picture of one??

[1937hd]

20201213_123223.jpg20201213_181003.jpg

[1937hd]

Panhead tool.

[Rubone]

45 clutch tool, works on both '40 and earlier and '41 up clutches to remove lock nuts (and adjust spring pack spacing on the early one) DCP_3959.JPG .

[aumick10]

Thanks, I have 4 motors to build for myself. You interested in selling that one? Cheers

[Rubone]

Rubone, when you say 30's up style for the crank jig, does that mean that the JD cranks do not fit in that style. I am looking to but a truing jig for JD's, and want to make sure I get the correct one.

They will fit fine, I am just referring to the time frame it was produced for, there are a couple earlier versions that do not do the later cranks due to width constraints.

[aumick10]

Rubone, when you say 30's up style for the crank jig, does that mean that the JD cranks do not fit in that style. I am looking to but a truing jig for JD's, and want to make sure I get the correct one.

[Rubone]

Flywheel truing stand, 30s up type
DCP_2245.JPG

[1937hd]

20201211_060646.jpg

[1937hd]

This is the tool I use all the time. 20201209_185952.jpg