Fixture

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • T. Cotten
    replied
    Many Thanks, Larry!

    My browser couldn't get past the chuck-like things on the left.
    Now if they would only offer a replacement belt for my LBN pedestal grinder; Carl O. gave me a serpentine belt number,... but it don't fit my fossil.

    I swear I will finally get a second lathe in duty this winter, I swear, and most likely I will be conjuring flatbelts for it as well as the ancient Sunnen.
    (A fellow at Davenport gave me a critical clue for a source... but it doesn't browse up for me either.)

    Steve's efforts are most admirable!

    ....Cotten
    Last edited by T. Cotten; 10-06-2016, 11:36 AM.

    Leave a comment:


  • larry
    replied
    For nearly 100 years, Sunnen has built a global business around delivering the highest levels of precision to our customers.


    I think this is it.

    Leave a comment:


  • T. Cotten
    replied
    Originally posted by larry View Post
    Clever, and it uses the same tool as the rocker arm operation. A tool I never knew existed.
    And I still can't find it on the Sunnen site.

    ....Cotten

    Leave a comment:


  • larry
    replied
    Clever, and it uses the same tool as the rocker arm operation. A tool I never knew existed.

    Leave a comment:


  • Steve Little
    replied
    After I had done this "in head designing", I thought, Right!! Here we go.
    A tiny voice in my head...(the sane part) said Wait a minute!! Do a couple of measurements to see what's needed. After a mili second of mental wrestling I succumbed, and resentfully flicked the tape here...did some thoughtful, ruler taping on the job for a minute, (to fool myself that I was taking this seriously) and did a quick scribble Whallahh!!
    1-1/2” round bar should be right. It'll be tight but the kicker arm should slide in between the jaws, without loosening them. Which will make change over fast.
    When it was all done, I measured the clearance between the kicker arm and the chuck jaw....0.002”. Now I have to admit that was a little close for comfort. But hey.. A miss is a miss.



    Quick clean of the centres



    Leave a comment:


  • Steve Little
    started a topic Fixture

    Fixture

    While I was using the external hone in the rocker arm thread, I was thinking of another use.
    Did a bit of mental design work and found a bit of stock to start the process.



    Little bit of turning.



    Push this back in here and tighten up.



Working...