64 FL Compensating Sprocket Fit?

[grollock]

I recently purchased a 64 FL that had a belt in the primary.
I have located the parts needed to convert it back to a chain
including a compensating sprocket. It seems that the sprocket
shaft isn't long enough to accommodate the compensating sprocket
without compressing the spring 1/2 inch to start the threads. Not easy.
My Question Is: Was the sprocket shaft longer on models equipped with
compensating sprockets from the factory? Thanks, Gary

[BigLakeBob]

No the shafts were not longer. Can you post some pictures with measurements of the spring and nut? All pan parts and no shovel right? Bob AMCA#6738

[grollock]

Here are the pictures Bob. Thanks.

[kg993]

Does that nut have a grease fitting in the outer end? It is too short compaired to mine. The distance in picture #2 should be 2 1/4" plus a little. This is from a set stamped 55A.

[BigLakeBob]

I would say the nut is incorrect or the length has been altered, it just looks too short. I agree with Kerry. Bob

[grollock]

I looked at a picture on J&P's website and the difference in length is quite obvious.
Bob and Kerry, Thank you both for your help. Take care.
Gary AMCA # 7334

[Paul G Bergeron]

hi gary tried to call you left message on phone call pete thanks paul g bergeron 7989