Announcement

Collapse
No announcement yet.

Factory H-D Tools

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #76
    Originally posted by aumick10 View Post
    Rubone, when you say 30's up style for the crank jig, does that mean that the JD cranks do not fit in that style. I am looking to but a truing jig for JD's, and want to make sure I get the correct one.
    They will fit fine, I am just referring to the time frame it was produced for, there are a couple earlier versions that do not do the later cranks due to width constraints.
    Robbie Knight Amca #2736

    Comment


    • #77
      Thanks, I have 4 motors to build for myself. You interested in selling that one? Cheers
      Last edited by aumick10; 12-12-2020, 06:30 PM.

      Comment


      • #78
        45 clutch tool, works on both '40 and earlier and '41 up clutches to remove lock nuts (and adjust spring pack spacing on the early one) DCP_3959.JPG .
        Robbie Knight Amca #2736

        Comment


        • #79
          Panhead tool.
          Attached Files

          Comment


          • #80
            20201213_123223.jpg20201213_181003.jpg

            Comment


            • #81
              Hey Robbie, did the MoCo have a tool for Shovelhead/Ironhead rocker shaft end caps with the slot? You got a picture of one??

              Comment


              • #82
                Originally posted by 1937hd View Post
                Panhead tool.
                I have the tool that you are displaying, but mine has the spring and rubber bushing that is shown in the catalog. My question is what is the purpose of the spring and bushing? It's easy to figure what to do with the tool itself.
                Craig

                CIMG1927.JPGCIMG1928.JPGCIMG1966.JPG

                Comment


                • #83
                  '41 up 45 clutch hub nut wrench
                  DCP_3960.JPG
                  Attached Files
                  Robbie Knight Amca #2736

                  Comment


                  • #84
                    Piston pin lock ring tool for "L" section lock rings
                    DCP_3984.JPG
                    Robbie Knight Amca #2736

                    Comment


                    • #85
                      Piston pin lock ring tool for spiral locks. DCP_3553.JPG
                      Robbie Knight Amca #2736

                      Comment


                      • #86
                        BT mainshaft starter clutch and bearing puller
                        DCP_3951.JPG
                        Robbie Knight Amca #2736

                        Comment


                        • #87
                          Ignition Timing Gage 95882-63 for gaging top dead center. CIMG1929.JPGCIMG1930.JPG

                          Comment


                          • #88
                            Inlet Housing Nut and Crank Case Bolt Wrench 11903-X for 1929 and earlier big twins. CIMG1944.JPGCIMG1945.JPGCIMG1946.JPG

                            Comment


                            • #89
                              Crankpin and shaft nut wrenches assorted sizes.
                              DCP_3990.JPG
                              Robbie Knight Amca #2736

                              Comment


                              • #90
                                Piston Pin Pusher Tool 11910-X ( missing the handle, guide pin, and pusher collar. CIMG1954.JPGCIMG1955.JPGCIMG1969.JPG

                                Comment

                                Working...
                                X