Announcement

Collapse
No announcement yet.

Factory H-D Tools

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #61
    Pushrod lifter
    DCP_3390.JPG
    Robbie Knight Amca #2736

    Comment


    • #62
      Some small assorted 20201209_203115.jpg tools.

      Comment


      • #63
        Save time and money in oil changes and flushes.You don't have to worry about stripping out oil tank plugs. 20201210_065044.jpg

        Comment


        • #64
          I would also be in for one of your Clutch Hub Pullers Mark.

          Comment


          • #65
            20201210_172741.jpg

            Comment


            • #66
              Originally posted by 1937hd View Post
              Lightweight flywheel tool, to clean up the recess for the stuffer plates.
              Robbie Knight Amca #2736

              Comment


              • #67
                It may be helpful to add a description with the pictures. Not everyone knows what all these tools are and what they are used for.

                Craig

                Comment


                • #68
                  20201211_060143.jpg

                  Comment


                  • #69
                    No problem. 20201210_172800.jpg

                    Comment


                    • #70
                      Originally posted by 1937hd View Post
                      Here is the working end of the tool, the hole goes on the flywheel shaft, the handle turns the tool, and the cutter cleans the recess of old staking ears. The screws allow adjustment. The small through hole is for alignment of the staking punch.
                      image_26493.jpgimage_26494.jpg
                      Last edited by Rubone; 12-11-2020, 12:29 PM.
                      Robbie Knight Amca #2736

                      Comment


                      • #71
                        Originally posted by badger34
                        Thanks guys! I was unaware of this tool and had previously wondered about how the recess was cut. Upon seeing the tool identified here I dug into the binder that my grandfather put together for our ST and found the tool page I posted above. I figured out the flywheel pinion hole and handle myself but wanted to see the cutting tool. In talking with my father it wasn't long after the ST was purchased through the H-D front office that he and my grandpa did the engine modification work, I would hazard a guess that grandpa brought the tool home from experimental to cut the stuffer recess.
                        All the standard cranks came with the steel "compression plates" in them from the factory. They had to be removed to install a new crankpin, hence the need for the tool. Most performance mods involved an aftermarket stuffer plate to reduce crankcase volume. It was a plate inserted between the flywheels and captive by the case halves.
                        Robbie Knight Amca #2736

                        Comment


                        • #72
                          This is the tool I use all the time. 20201209_185952.jpg

                          Comment


                          • #73
                            20201211_060646.jpg
                            Attached Files

                            Comment


                            • #74
                              Flywheel truing stand, 30s up type
                              DCP_2245.JPG
                              Robbie Knight Amca #2736

                              Comment


                              • #75
                                Rubone, when you say 30's up style for the crank jig, does that mean that the JD cranks do not fit in that style. I am looking to but a truing jig for JD's, and want to make sure I get the correct one.

                                Comment

                                Working...
                                X