1937 ULH low Cylinder Pressure

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • shinedogg
    replied
    I'm checking all of that today, Thanks

    Leave a comment:


  • HDSmitty
    replied
    Rings on upside down? Valves seating properly?
    Last edited by HDSmitty; 03-12-2020, 11:58 AM.

    Leave a comment:


  • tfburke3
    replied
    Any chance the cam timing is off?
    Tom

    Leave a comment:


  • Rubone
    replied
    Clutch not slipping?

    Leave a comment:


  • shinedogg
    replied
    Yes, wide open

    Leave a comment:


  • Rubone
    replied
    Throttle wide open for the test?

    Leave a comment:


  • shinedogg
    replied
    Oh, annealed copper head gaskets.

    Leave a comment:


  • shinedogg
    started a topic 1937 ULH low Cylinder Pressure

    1937 ULH low Cylinder Pressure

    Ok guys, here we go again. I went and bought new cylinders from CycleFab, with fitted pistons and valves. I had my head surfaces checked on a friends CNC Mill, they were warped, it took .020" to get them flat. Put her together and it felt like no compression when I kicked her. I put a quality compression gauge and 22 PSI. I squirted a little Corrosion X in and 26 PSI.Double checked the valve clearances and perfect. Now, with milled heads and new cylinders with fitted pistons, my PSI should be up there a little more. Only answer would be a HUGE ring gap, or possibly the cylinder decks didn't get machined enough? She's on the lift begging to get tore down, but I may be missing the obvious????
Working...