Tweet
Peter;
Okay Professor Question:
"(Y)ou want to verify exactly where you go into coil bind on release. . .
(1) measure the height of one spring collapsed, [Okay got it]
(2) then the stack height of the assembled clutch plate’s distance to the u derisive of your
pressure plate. [?????] PLEASE Clarify:
"distance to the u derisive of your pressure plate"
On this picture I copied from Jerry Geers Is the "u" you are referencing the depression for
the release or throw-out bearing?????
Release Plate aka Pressure Plate.jpg
Thank You.
Okay Professor Question:
"(Y)ou want to verify exactly where you go into coil bind on release. . .
(1) measure the height of one spring collapsed, [Okay got it]
(2) then the stack height of the assembled clutch plate’s distance to the u derisive of your
pressure plate. [?????] PLEASE Clarify:
"distance to the u derisive of your pressure plate"
On this picture I copied from Jerry Geers Is the "u" you are referencing the depression for
the release or throw-out bearing?????
Release Plate aka Pressure Plate.jpg
Thank You.
Comment