Tweet
Greetings
I am trying to put turn signals on my 64 panhead. The fronts are not a problem, the rear's have become a challenge. Judging from the holes where the signal bar mounts, this bike didn't come with turn signals from the factory. The holes look like they were hand drilled and there's no holes for the wires. I would guess that the wires run in the same metal loom as the taillight wires and come out in the same place, but that's only a guess. where should the wires go through the fender at? Any idea on where the wiring might tie in at?
Thnaks
Max
I am trying to put turn signals on my 64 panhead. The fronts are not a problem, the rear's have become a challenge. Judging from the holes where the signal bar mounts, this bike didn't come with turn signals from the factory. The holes look like they were hand drilled and there's no holes for the wires. I would guess that the wires run in the same metal loom as the taillight wires and come out in the same place, but that's only a guess. where should the wires go through the fender at? Any idea on where the wiring might tie in at?
Thnaks
Max
Comment