Tweet
Dash-Mounted Linkert Choke Control
Does anyone know if the Air Intake Shafts, 27216-46 ('46-'48) or 27217-48 ('49-'53) can be replaced with shafts from another model Linkert? Also, does anyone on this site have any of the parts for this choke control available (see page 45 of the '41-'54 Spare Parts Manual) or know of a source. I have the 29455-46 bracket and 27250-46 lever. Thanks in advance for any assistance or advice.
-
Lonnie Campbell #9908
South Cackalackey, U.S. of A.
Come see us at the Tenth Annual AMCA Southern National Meet - May 17-19, 2019 at Denton FarmPark, Denton, N.C.
Visit the website for vendor and visitor information at www.amcasouthernnationalmeet.com -
Hello i have part 29453-46 choke contol coil holder and 7815 nut also the lock washer.there yours if you want them. -
Just back last night and saw your reply, I've sent a PM. I want to install it on Barney, my 1950 pan. The tanks were widened I'd guess in 1954 and the choke lever is a PIA to reach. Thanks.Last edited by Lonnie; 01-07-2013, 06:59 AM.Lonnie Campbell #9908
South Cackalackey, U.S. of A.
Come see us at the Tenth Annual AMCA Southern National Meet - May 17-19, 2019 at Denton FarmPark, Denton, N.C.
Visit the website for vendor and visitor information at www.amcasouthernnationalmeet.comComment
-
IMG_0636.jpg
Lonnie,
Is this the choke control your gathering parts for? If so I think Diesel55's parts are for a "Catseye" style dash.
TimComment
-
Hello tim you are correct ..Comment
-
Its all the same kit, no matter which style dash you are trying to use it on. The complete kit comes with all the parts to mount it to either style dash and there is a template to drill the 46 and earlier style dash to use this kit with it.Comment
-
Lonnie!
Have you tried a common -33 sidevalve shaft yet?
The only difference that I can imagine would be the indexing of the lever's set screw.
Beware that modern reproductions of the -33 shaft are often drilled wrong anyway!
....CottenAMCA #776
Dumpster Diver's Motto: Seek,... and Ye Shall Find!Comment
-
I have not but will see if I have one. Thanks.Lonnie Campbell #9908
South Cackalackey, U.S. of A.
Come see us at the Tenth Annual AMCA Southern National Meet - May 17-19, 2019 at Denton FarmPark, Denton, N.C.
Visit the website for vendor and visitor information at www.amcasouthernnationalmeet.comComment
Comment