Question about tappet blocks for a 45WL. I was removing my blocks and I got a little over aggressive, resulting in a chipped off corner. Started searching around for a replacement and I find some people listing them as front or rear. Are my eyes missing a detail? Because all four of them all look the same to me.
-
Member# 7397 -
If you compare the slot in the bottom where the roller sits to the bolt location you will see that front and rear have different oririentation.
Jerry -
Absolutely... 2 front...2 rear.Comment
-
I take it from your post you were prying on the ears, a big NO-NO. There are several types of special tools made to remove them, and heat is highly recommended! And yes, they are front or rear.
RobbieRobbie Knight Amca #2736Comment
-
Got it! I was looking too hard at the tops to find a difference, to see the bottoms.
So I do need to find a rear.Member# 7397Comment
-
I have an nos rear to spare. Make an offer. Email direct for pics. vtwinrebuild@yahoo.com
PapsComment
Comment