’35 VL Rear Stand Catch

[wideglide38]

I need some dimensional help for the holes on the rear mudguard (’35 VL) to mount the rear stand catch. What I am looking for is the center-to-center distance between two holes - the top hole for the rear stand catch and the lower hole for the tail lamp/license plate bracket. I seen several photos and the distance looks roughly 1-1/2” but I'd liked to be sure before drilling. With the hole for top of the catch, I figure out the lower hole.
Thanks, William

[Steve Slocombe]

Looks like 1 7/8th inches on one of my bikes, but these are new mudguards so I would have guessed too. Check out VL Heaven Website new additions for another measurement up from the rear mudguard tail.

[wideglide38]

Thank you Steve

[1970 XLCH]

On my '34 VLD the distance from the bottom of the fender to the bottom hole of the rear catch is 3.00" . The taillight shroud should dictate where the taillight holes go . I'm too lazy to take off my license plate , but I will if this does not answer your question .

[wideglide38]

Thanks 1970XLCH