I’m currently piecing together a ’47 WL from many various & unrelated parts that I’ve been collecting for several years. It’s getting pretty close, although there is still a lot of work left to do.
What I’m looking for is info on the routing of the wiring.
I have a repop ’47 only harness (which is actually about 13 or 14 separate pieces). I have a wiring schematic, & I do understand basic wiring, so for the most part I know what needs to be connected to what.
What I have to figure out is which piece of the harness to use for each run. I think I’ve figured out some of it on my own, but there are several things that I can’t seem to get sorted. For example, there are two pieces which each have one red, one green & one black wire. Which one goes where? There’s another one which has one red, one green & two black (but there doesn’t seem to be a harness in the schematic that has these four wires…). On another spot on the schematic it seems to show a harness that has a green wire that’s split in the middle, but there is nothing like that in the kit I’ve got.
So I’ve now decided what would really help is some pics of the routing. Anybody got any good photos of the routing for a ’47? If you have pics of Knuck or BT Flatty wire routing, I’d like to see that too, cuz they are nearly identical. I’m also looking for pics that show the terminals, cuz lots of wires have ring terminals on one end & flag type on the other. Other info that might help would be the length of various wires, cuz there are several wires that are identical except for the length. So, most any guidance would be welcome.
Over the years I have occasionally tried searching this forum for an answer. But today I’ve not been able to find what I need (maybe it’s not in there, or maybe I’m no just good at searching …).
I tried asking this question on another forum with no results so far, so I’m hoping someone here can help.
Thanks very much!
What I’m looking for is info on the routing of the wiring.
I have a repop ’47 only harness (which is actually about 13 or 14 separate pieces). I have a wiring schematic, & I do understand basic wiring, so for the most part I know what needs to be connected to what.
What I have to figure out is which piece of the harness to use for each run. I think I’ve figured out some of it on my own, but there are several things that I can’t seem to get sorted. For example, there are two pieces which each have one red, one green & one black wire. Which one goes where? There’s another one which has one red, one green & two black (but there doesn’t seem to be a harness in the schematic that has these four wires…). On another spot on the schematic it seems to show a harness that has a green wire that’s split in the middle, but there is nothing like that in the kit I’ve got.
So I’ve now decided what would really help is some pics of the routing. Anybody got any good photos of the routing for a ’47? If you have pics of Knuck or BT Flatty wire routing, I’d like to see that too, cuz they are nearly identical. I’m also looking for pics that show the terminals, cuz lots of wires have ring terminals on one end & flag type on the other. Other info that might help would be the length of various wires, cuz there are several wires that are identical except for the length. So, most any guidance would be welcome.
Over the years I have occasionally tried searching this forum for an answer. But today I’ve not been able to find what I need (maybe it’s not in there, or maybe I’m no just good at searching …).
I tried asking this question on another forum with no results so far, so I’m hoping someone here can help.
Thanks very much!
Comment