Picked up a springer for my Servi-car. I noticed one of the rocker arm mounting tabs on the rear leg is not straight. What would be the best way to tweak it back straight. I was thinking about clamping the tab in a vice and easing it back in alignment with the other with some well placed grunts. My question is would I need to apply heat? Am I over thinking this? It would suck to break it off by not know what I was doing.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment