Contact Braker Unit Removal

[R.C.]

Have a '67 T120R, I need to remove the contact braker unit. Can anyone tell me if this can be done without the use of special service tool D782. Thank you, R.C.

[AdminGuy]

On a 68 T100 you can use the front tank draw down bolt. Same thread & OD. Use rubber mallet gentil like, to ease it out. Tapered press fit. Some have locateing pin on shaft. Maybe mark it -before you pull it.

[R.C.]

Thanks will try today. R.C.

[TOK]

contact breaker removal

Hi.

I also have a 67 Bonnie that I need to remove and reinstall a better used cam.
So How did it go??
Any suggestions or advise, tips tricks??

Thanks
TOK

[R.C.]

: It was a long time ago. I remember that I made a tool using a hardened bolt that I ground to fit inside the shaft. Then I think that with a few taps with a hammer the backer plate came off> Good luck, R.C.