Removing stuck original wiring from fender

[rms337]

I have original wiring that is stuck inside the rear fender that I am trying to remove. There is nothing extra on the ends to pull on thanks to my prior attempts to get the two wires out. There are minor ends to work with at the inside pivot point, but I have left that alone until I get some ideas.

Any tips or suggestions are greatly welcome!

[Lyle Manheimer]

More in information would help. Here goes. Lube with WD-40 let it sit over night. If it is the penetration in the fender, after siting overnight, take a piece of round stock smaller than the hole, grind a taper on it and try to push it through. Is the fender on the bike? Is it original paint? Is it even stuck in a hole? Not sure what you mean by pivot point.

[vride5]

High pressure air, try from the hinge out.