Looking to put the bigger oil pump drive gears in a '52 FL motor. H-D doesn't make them any more. Does anyone know an after-market manufacturer who does? I know they come as a pair, one that goes on the pinion shaft, and one that goes on the oil pump shaft that's in the timing cavity. Any help greatly appreciated.....Cheers.....Omar
X
-
-
The gears were never made for a splined shaft by H-D. They only made them from the early '70s up but due to the shaft design they fit back to '54 ( or earlier if the shaft, case race, pinion gear, rollers, etc were also changed). Splined versions were always aftermarket.Robbie Knight Amca #2736
Comment
-
-
Hey, kitabel, who is IIRC? Bought the upgrade oil pump drive gears from S&S, and the one that goes on the pinion shaft is too small to fit on the shaft. From what I can measure, the shaft is .848" over the splines, but the gear is .843" (.005" interference!!!!) Typed in IIRC to do an internet search and didn't get anything m/c related.
Comment
-
Originally posted by Omarttentmaker View PostHey, kitabel, who is IIRC? Bought the upgrade oil pump drive gears from S&S, and the one that goes on the pinion shaft is too small to fit on the shaft. From what I can measure, the shaft is .848" over the splines, but the gear is .843" (.005" interference!!!!) Typed in IIRC to do an internet search and didn't get anything m/c related.Robbie Knight Amca #2736
Comment
-
This is the first I've heard of S&S having a "JIM'S" problem (looks good, can't fit w/o major work).
Is S&S now pronounced "Beijing"?
Comment
-
I have been enlightened by the panhead manual. On page 170 there is information re/ an upgraded pinion shaft that was introduced in late '51. This shaft is larger in diameter so that the pinion gear is a press fit on the shaft. The press can be up to .002", according to what I read. That means that the inner splines on the oil gear that goes on the shaft would have to be bigger, as I am sure that it is not a press fit. A special tool is required to remove and install the pinion gear, but no mention is made of the oil pump drive gear. I know this is the upgraded pinion shaft because it has a screw in its end. So when s&s advertises the oil pump drive gear update, it's actually misleading. It should read '39- late '51. The gear for those models will not fit on late '51-'53 motors. Of course, my confusion is only compounded by the fact that the pinion gear that came off is a slip fit on the shaft. Don't know if that's due to wear, or if somewhere along the way it was reworked to be a slip fit on the upgraded shaft. FYI.
Comment
Comment