carburetor repair

[T. Cotten]

..Having the skill required to perform the tasks is the problem.

As well as an arsenal of machinery and tooling, Scott,.

Mine will likely be scrap.

....Cotten

[sswaney]

Tom, thanks for sharing the checklist.
Much food for thought there.
Having the skill required to perform the tasks is the problem.

[T. Cotten]

"eye surgery put me out of action."

Tom, Sorry to hear you are having problems with your vision.
I have had a few "issues" there myself. Still have one solid peeper so fingers crossed,

Thanks for the sympathy, Paul,..

But they trashed both of mine; My career as a machinist is over.

Need to liquidate.

.... Cotten

[PaulCDF]

"eye surgery put me out of action."

Tom, Sorry to hear you are having problems with your vision.
I have had a few "issues" there myself. Still have one solid peeper so fingers crossed,

[T. Cotten]

What's it need?

Here's a rough general checklist, Scott!

(Suggested flat-rate times to be adjusted as appropriate; No two are alike, even if the same model...)

Disassembly and inspection 20 minutes
Flame/Drill out frozen plug 10 ea
Pull frozen nozzle 20

Chemsoak / prep to conserve original finish 20

Double-blast bowl; remove hammermarks and re-texture 30
Prep as “Nickel” 15

Blast Hardware and findings 10
Hardware prep and detailing 30

R&R throttle shaft bushings; line hone-fit 20

Install choke shaft bushings; line hone-fit 30

Dress to flat manifold flanges; Aircleaner, bowl decks _____ @ 5

Lathe-cut 3-bolt flange 20

Weld-out detent ball 10
Restake 5

Replace nozzle spigot 15

Stake ‘n peen choke shaft 5
Roll-peen choke shaft 10

Hone damaged body bores 20

Cut oversized throttle disc 30

Swage-form venturi for fit 20
Custom-cut venturi, material included 60

Lathe-dress needle point ____ @ 5 ea

Helicoils first 10
additional 5 ea

Re-cut HS needle seat 5

Re-cut floatvalve seat; Burnish floatvalve needle to seat 15

Cut Durable float 60

Die-press floatlever pin bore and ream 5

Scrub for assembly: Body; bowl each 5

Reassemble and adjust body 30

Reassembly bowl; adjust 30



Every one is different, Folks; This DLX64 needed extra attention:
64WEAR1.jpg

....Cotten

PS: Finished conservation:
DLX64RGT.jpg
DLX64LFT.jpg

DLX64FRT.jpg

[sswaney]

"looking for recommendations on who can repair schebler dlx 64, carburetor .thanks"
What's it need?
A picture would be helpful.

[T. Cotten]

Thanks Jerry,

But eye surgery put me out of action.

.....Cotten

[Jerry Wieland]

Tom Cotten

[cscott]

looking for recommendations on who can repair schebler dlx 64, carburetor .thanks