Tweet
I would like to replace the gear that is pressed into the large bevel gear on my 36. The one I now have is pitted. No one seams to have this gear. Roy Davies has a lot of parts, but not this part. I would consider a used one at this point in time. Even a set of bevel gears with the gear attached. Anyone know of someone that may have the gear? Thanks Stan
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here