I have a '51 or earlier transmission that I am modifying for my '52 Chief, and was wondering about the oil level hole that is supposed to be on the output side of the transmission. Mine has the cast in indent for a plug, but it is not drilled and tapped. Is this the same 1/8" pipe thread plug that is used elsewhere?
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment