steps to restoring 48 chief

[bigmikecar]

hello i posted this in another post but here its goes again. rolling chassis powder coated and ready to go tires brakes forks kick stands bars done . fenders sheet metal lights trim mocked up ready to dis assemble. what should be my next step while i wait for motor and painted parts to come back. should i start wiring or wait what next ?

[exeric]

What about all of the cadmium plated parts? There is usually quite a bit of prep, to get that stuff plater ready.

[bigmikecar]

all hardware new brake and clutch linkage ,footboards new m.c.

[tomfiii]

Just make a note to remember to install top motor mount before installing motor.

[indianut]

Be sure and Remove all of the Powder coating from the Trans Mount Tab and the Inside of the Motor Mount lugs on the Frame. At Least!