Tweet
Time to run the wires to the lights mounted on the rail shown in the photo. Can anyone enlighten me as to where the wires exit the rear fender?
-
-
This set up was used on 1968-1976 models. No one has a rig like this from those years? -
Not a factory installation, either after market or factory accessory. Install was probably custom from day one. Wires likely could be run inside the horizontal chrome bars, but the exit from fender to the bars is going to be hard to conceal. Wish I had more for you, good looking bike. Good luck.Comment
-
I decided to leave off the lights, for now.
Yes its a beautiful OP, low mile bike. Not mine however. Belongs to a friend. Here's a walkaround video of his bike:
https://youtu.be/M4RWdYA24PM
Comment
Comment