Say can someone point me to a hobby/restoration machinist guy with a lathe? I am in the Daytona Beach area so a 50 mile or so drive/ride is doable for me. I need to have sized a new reman 1972 caliper piston to the caliper bore for a 1972 FLH and does anyone know what the minimum/maximum clearance numbers are? That info, if there ever was any, is not readily available in the service manuals I own. Thanks
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment