Here a new stumper boys. Picked up a used tranny plate the other day. The front holes are 3.250 on center which makes it 58 up. Now the clincher? The front holes are 5/16” not 3/8”. Anyone got an answer for this. Bob
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here