Tweet
This hinged rear fender end has been sitting on my shelf for at least 25 years and never paid much attention to it till now. It appears to be a NOS part that had been badly stored with a -58 part number visible. There are no holes in the upper part of the flap where it would have been secured to the rear fender support brace. Any ideas on this? IMG_3681.JPG IMG_3683.JPG IMG_3682.JPG IMG_3680.JPG IMG_3684.JPG
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here