While getting ready to install new seals in my glide front end I got to wondering about how loose the tubes can be. The service manual was no help other then saying they should be a tight fit. I wouldn't say they are a tight fit, so if I have some play does that mean I need new bushings. I'm tempted to run them and see how they function.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here