valve guide clearance 47 Fl

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • jorrow
    replied
    Thanks guys...

    Leave a comment:


  • Carl Olsen
    replied
    I have been setting them up at .004 on the intakes and exhausts for years and have had no problems. Always use a coated valve and cast iron guides, never use bronze or amco 45 guides. My 39 EL has over 30,000 miles on it after restoration and still uses a half a quart of oil in 3500 miles.
    Carl

    Leave a comment:


  • indianut
    replied
    Originally posted by jorrow View Post
    I'm rebuilding the top end of my 47 Fl. The harley manual calls for .004 clearance for the valve to guide clearance...but I'm using stainless and heat treated black diamond v twin valves..can I get away with less clearance..does anyone have any experience with these clearances and modern parts.. Jeff
    No. .004 is as tight as you want to go. I would NOT go that tight on the Exhaust! I Always go to the Loose side of the spec.

    Leave a comment:


  • jorrow
    replied
    V twin cast iron guides.

    Leave a comment:


  • Chris Haynes
    replied
    What kind of guides are you using?

    Leave a comment:


  • jorrow
    started a topic valve guide clearance 47 Fl

    valve guide clearance 47 Fl

    I'm rebuilding the top end of my 47 Fl. The harley manual calls for .004 clearance for the valve to guide clearance...but I'm using stainless and heat treated black diamond v twin valves..can I get away with less clearance..does anyone have any experience with these clearances and modern parts.. Jeff
Working...