bead blast or not
Collapse
X
-
Ain't you gonna ask about 'encapsulating', Stroker?Originally posted by stroker View Postthanks cotten
Its more important than even pleasing the judges.
....Cotten
PS: Vapor blasting certainly sounds like it would cut down on the dust. I burnt up another collector last week.
Leave a comment:
-
Sand sticks because its sharp, Stroker!Originally posted by stroker View Postthanks larry i dont need sand or glass coming loose later on
That, and things like 'black beauty' and even ALOX embed, but sometimes something aggressive is still a necessary first step. Then more steps to prep that properly,.. and finally encapsulating internal surfaces. Sometimes dressing external welds and boogers, you may want to focus some steel shot, before beading it all at high enough pressure that it 'bounces', and finally ADALOX soft brushing.
So maybe judges think this 'vapor blast' is closest to "as it left the factory"?
....CottenLast edited by T. Cotten; 03-12-2022, 11:00 PM.
Leave a comment:
-
I try to avoid sand or glass bead on engine parts as the media gets trapped in the metal to be released later. Baking soda blasting dissolves in water. In many cases, scrubbing by hand proves sufficient.
Leave a comment:
-
vapor hone is wet bead blasting leaves a shinny finish high point is what are amca judes looking for or accepting
Leave a comment:
-
Please explain "stock high point type of finish". Stroker...
And "vapor hone", too.
I'm not too old to learn new ways!
....Cotten
Leave a comment:
-
bead blast or not
i am restoring a 47 knucklehead and want to know the best way to prep my motor and tranny cases bead blast vapor hone or hand clean with simple green or something thanks in advance i'm trying for stock high point type of finish and don't want to mess them upTags: None
Leave a comment: