Having trouble installing the cycler inside wiring lamp holder-socket-to the reflector. The 3 spring loaded pins are basically the same size as the opening and to get into the slots I do not want to bend or break the assembly, can get 2 in but the third is even with the slot, therefore cannot fit over to slide back in. Any help would be appreciated. Thanks
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here