Regarding brake shaft lock washer 42575-30 it’s obvious that a tab bends over a flat on the nut but what keeps the nut and washer spinning together? Does one of the long tabs get bent over something and if so what? Thank you.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment