Complete knucklehead heads from Tedd's V-twin.

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • FNG1
    replied
    Hi Cotton, thanks, I am putting together a pressure tester today. How much pressure, 5, 10, 15 PSI? All of my bikes had spigots, (Triumph), rubber bands or O rings and were checked with carb cleaner or an unlit propane torch after startup. I have almost no experience with plumbers style manifolds. Thanks for any input. Should I use any sealant, or silicone grease, or just clean brass. Not going with peek unless I have issues, or is that what everyone uses? Should (or can) you anneal the brass.
    Last edited by FNG1; 09-12-2018, 05:20 PM. Reason: Added pic

    Leave a comment:


  • T. Cotten
    replied
    FNG1!

    It looks like a Colony manifold.
    An eighth inch on each side works with properly fitted PEEK seals. No spacers necessary.

    I'd bubble-test the inlet nipples and whatever that is for a rivet before I worried about the manifold width...

    Good luck,

    ....Cotten

    Leave a comment:


  • FNG1
    replied
    Hi Rollo, the manifold is 3 9/16"

    Leave a comment:


  • Rollo
    replied
    Sure you don't have 61 and 74 parts mixed up in there? The 61 manifold is shorter and the cylinders are shorter. Might have 74 cylinders and 61 manifold. Just asking.


    Tom (Rollo) Hardy

    AMCA #12766

    Leave a comment:


  • FNG1
    replied
    Just like anything else, new, used, or repop. The heads I got with my pile of parts have already been gone over. One issue I had was just over a 1/8" gap between the heads and an aftermarket manifold. I turned two rings 1/16" by the O.D. and I.D. of the manifold and slipped them into the seals to keep the manifold centered.











    Leave a comment:


  • KNUCK
    replied
    Originally posted by Tom O'Ryan View Post
    Knucklehead Theology did a review on those heads. You might want to read what he had to say http://knuckleheadtheology.blogspot....klehead%20Tech
    I would say a must read here. This would be a product that could be used if re worked by a pro shop to make it function properly.

    Leave a comment:


  • FNG1
    replied
    thanks for the link Tom O', great read. I am using older but unused VTwin heads and cylinders that came with my 41FL.

    Leave a comment:


  • kitabel
    replied
    My concern with anything from Ted would be linear to my opinion of his business ethics.

    Leave a comment:


  • Tom O'Ryan
    replied
    Knucklehead Theology did a review on those heads. You might want to read what he had to say http://knuckleheadtheology.blogspot....klehead%20Tech

    Leave a comment:


  • vph-d
    replied
    Anything from V-Twin with moving parts. Probably those without moving parts, too!
    VPH-D

    Leave a comment:


  • Chris Haynes
    replied
    Check anything before you use it.

    Leave a comment:


  • Complete knucklehead heads from Tedd's V-twin.

    A friend recently bought a set of assembled 1940 to 1947 knuckle heads from Tedd and we are wondering if a guy can 'put them on and runn'em' or are there things we need to check first?

    Jerry
Working...