Tweet
I am installing new pistons and rings in my 1956 G Harley flathead motor. Rings from Eastern are #H-4244-030, I believe Hastings rings. The oil ring is the one-piece ring. Two upper rings appear to be identical with dot and interior bevel on same side as dot. Do the dots face up on both 1st and 2nd rings. That would make both inside bevels face upward also. No instructions included with rings, and I cannot find answer on Hastings tech page. Cannot call Hastings tech since I need to install the rings this weekend. Thanks.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment