Tweet
I'm overhauling a rear axle to replace a bent axle shaft and I have a question about the outer bearing housings. I've heard that one is right hand threaded and the other, left hand threaded. I got the one on the "short" side removed with no problem using the Kemco tool and it was threaded normally (rotated counter clockwise to come off) but the other is on pretty tight. Before I bugger this one up can anyone verify that this one is left hand threaded?
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment