Goulding Rocket

[Chuck#1848]

Hi Neal, The original Goulding spun metal fronts were made in Saginaw. If you google spun sheet metal, you will come up with all different companys that may be able to help you out with this project. I don't know what the cost would be, but if you check into it, I would be interested to hear about it. Here is a link to the process.
http://www.kochmetalspinning.com/slide_show.html Good Luck.

Hi Neil,
A friend of mine in North Carolina had some made up, but the people that spun them left a grooved finish in the dome this company is in Ill called helander metal spinning in Lombard if I remember correctly.

The people at Koch in the link above from Clydeflathead are located in Buffalo the compainy that I work for has done business with both of them, IF you decide to go this route explain to them in full what your intentions are with the dome that you want them to spin also it's not going to be cheap you will get hit with a tool making charge to fab and form the mold for the dome.
If you want pm me and I will give you his e-mail info Good luck

[Clydeflathead]

Niel, They were made separate, chromed then attached. I believe you are real close, if not right on the money with 28" diameter. I think if you get the exact measurements, you can have it reproduced.

http://www.gouldingsidecars.com/Home.html

[Neil74]

Thanks for the ideas, the nose was originally chromed which is why I would like it to be spun in one piece. I'll get accurate dimensions tomorrow but it is approximately 28 inches in diameter and pretty much a ball cut in half. Does any one know how they were made? Chromed separate and then attached?

[chibobber]

Neal, may not be the best solution or a solution at all.I'm not to familiar with the shape of the nose,could you us a spun stainless mixing bowl.They come in many different sizes.Most have flat bottom that you could mount a headlight in. If antique plane restorers can use spun aluminum exhaust fan shrouds meant for restuarants,why not?
this is tongue in cheek,Lots of shapes in the world.Paul Friebus uses an aluminum flip style omelet pan,welded together for an oil tank on his 37 u bonneville bike.adapt and overcome.Good luck.
Bob

[Clydeflathead]

Hi Neal, The original Goulding spun metal fronts were made in Saginaw. If you google spun sheet metal, you will come up with all different companys that may be able to help you out with this project. I don't know what the cost would be, but if you check into it, I would be interested to hear about it. Here is a link to the process.
http://www.kochmetalspinning.com/slide_show.html Good Luck.

[Neil74]

Hi, the nose of my Goulding rocket has been sandblasted and a good sized hole welded shut. The previous owner used Fiberglass body filler to repair the patch. The repair patch is shaped like and the size of a slice of pizza. Is there anyone with the tooling available to spin a new nose or fabricate a cleaner patch which would need less filler.