Rowe Flywheel Jig 09-1194-00 Instructions

[wideglide38]

Does anyone have a scan of the instructions for the Rowe Flywheel Jig #09-1194-00 they can send?
Thanks,
William

[motorhead1]

Try this link. On the second page at the bottom is a brief description of it in use. You can also find reference to the jig in use in 1980 and later Big Twin and Sportster service manuals.

https://www.yumpu.com/en/document/view/11475948/09-1179-truing-instructions-rowe-usa

[wideglide38]

Try this link. On the second page at the bottom is a brief description of it in use. You can also find reference to the jig in use in 1980 and later Big Twin and Sportster service manuals.
https://www.yumpu.com/en/document/vi...tions-rowe-usa

Thanks motorhead1. I have the truing stand instruction sheet (I/S) and read rebuild jig details on Pg. 2. I had just wondered if there was a separate I/S for the rebuild jig. I am getting ready to walk out to end of the flywheel assembly "diving board" for the 1st time and give it a try! I'm researching all I can and am planning to rebuild an old disassembled '72 & later end oiling shovelhead flywheel set I have. William

[motorhead1]

I'll scan those manual pages for you later on this evening if you like.

[wideglide38]

Thank you for the offer. I'm good since I have a few manuals in hand ('84-'90 FLT/FXR, '85-'90 FX, '95-'96 FLT & Dyna plus knuck, pan & shovel service manuals).