Does anyone have a modern part no. for replacement bearings for a Splitdorf DU 1 generator? This is the earlier model with both bearings the same. The OD of the outer race is 1.00".
Thank you,
Jack
Thank you,
Jack
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here