Good day lads, I have a factory truing stand that I've never used. My question here is the hardware that came with it. The shaft that sits on top the stand has a shoulder on it that fits tight in the spindle on the brake side of the star hub. On the other side, all it has is a nut that screws on and cinches up against the thrust bearing sleeve. I thought about making a tapered cone to slide on that end but see no reason since the thrust bearing can move where ever it wants anyway. So boys, am I missing hardware here? Thanks, Bob L
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment