Tweet
Have a set of cylinders where the top head gasket surface is pitted, I would like to mill this surface so it is flat but would like to know how much I can safetly mill off the top without causeing any problems. Also I am looking for a lifter block puller for this 46 UL. v-twin sells them but they have been on back order for quite awhile now. From what I understand this puller only works on the UL models. Thank you for your help.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here