Tweet
Got an old Beck coil I'd like to put on my flathead. Wondering how the wires are attached. Some Beck coils that I've seen are marked + and - at the wiring studs, but this one is not. When looking at the coil as it is mounted on the bike, which stud gets the wire from the distributor, the one towards the front of the bike or the one towards the rear?
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here