I just picked up a really nice OEM inline springer for my 40 EL bobber. I see that you can run Timkens in them but am trying to debate on whether I should just go with the loose ball bearings like it was designed for. This is my 2nd springer bike the rest I've had were all hydra glides. My other springer I ran the loose ball bearings and it works fine. But would like to hear some advice.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here
Comment