I need a junk K-model cylinder. I don't need both and I don't care if it's a front or rear. Broken fins, shot valve seats, bored out to the max OK, I just need the base flange and spigot to be in good shape. Any leads appreciated. Thanks
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here