Fender Trim

[dukekleman]

I'm looking to purchase a set of these fender trim rails seen in the image.
IMG_20220118_174017108~2.jpg

[exeric]

That does look good, Duke. I have that set but I have the same rear fender trim intention as you. My problem is they need to be re-chromed. I believe the stanchions are the same as the optional bling used on instrument panel covers which I think is being reproduced. The rod is simple 1/4" round CRS. Chroming is the absurdly expensive part.

[dukekleman]

The photo is from my 1957 I restored years ago. I'm looking for a set for my 1950 FL now.

[JoJo357]

Duke, there's a bunch of them, long & short here on eBaY...*Good Luck.


Harley KnuckleHead Rear Fender Trim for sale <-----------

*M.A.D.*

[exeric]

I found this on the V-Twin site. I will probably buy from them before paying twice that amount to have my originals chromed.

https://www2.vtwinmfg.com/classic_pr...-rail-kit.html

[Rubone]

Be aware that some of the aftermarket and OEM pieces do not interchange, slight diameter differences, different stud size, etc. They came with either 4 or 5 stanchions depending on the saddlebag plates. They also were commonly used as top of fender trim which doubled as luggage attachment points. See the front fender on my wife's 47WL.
Tamara 47 45.jpg

[dukekleman]

Unfortunately, I was told by V twin they were discontinued as few months back.
I thank you all for the feedback on this post, much appreciated. Please keep me posted on any further leads.

Thank you,
Duke Kleman

[Highlander]

As for the chroming of the rods, I ordered some polished stainless from McMaster to advert the expensive chroming aspect on a similar application.

[dukekleman]

Highlander,

That was the route I planned on going as well if I can't find anyone with a set.

Thank you for the reply,

Duke Kleman

[otis71]

I have 4 3/8 stanchions if that helps

[paddy]

Duke PM SENT

[dukekleman]

Otis,

Thank you for the offer.
I need this design for the project.
IMG_20260311_102115389.jpg

Duke Kleman