Announcement

Collapse
No announcement yet.

Harley wheel truing stand arbor shaft.parts or dimensions

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Harley wheel truing stand arbor shaft.parts or dimensions

    I bought a Harley wheel truing stand without the arbor shaft parts. I need the shaft parts for the star, midstar hubs and later or any other parts of drawings with dimensions.
    Thank you,
    Ryan

  • #2
    Are these measures correct for the star hub adapter? I copied and pasted from another site.



    Posts: 591
    Location: Spokane WA USA
    Here are some measurements;
    Star hub axle adapter.
    This is a 2 piece,
    Shaft and A pressed on turned end to register into large end of roller bearing sleeve for star hub
    Start with a shaft 9" long, .875 Dia. Drill centers in ends.
    Diameters down the shaft; You might draw it out.
    .500"odx1"long, Chamfer-.075"up to the .875".x.185"long.
    Turn down the rest of length to .680"
    At 4.685" from the start end, the threads begin, Take up the next 2.80" of length.
    I got .623" thread height, Looks to be 5/8-11. My nut is 1-1/16"od. hex.
    The last length is again .500"dia.x1"
    Now the pressed on piece. 2.134"od.780"long,
    Bore it to press on the .680" shaft to the .875"x.185"L shoulder.
    Then the OD can be turned true.
    There are 3 diameters here, Most important is the 1"odX.120"L ,
    Goes into the hub spool big end, this faces the threads.
    3 diameters are 2.134"odX.250"L. 1.280"odX.400"L. then 1"odX.120"L toward threads.
    This will get You a Genuine looking adapter.


    The universal adapter is easier.
    Use a good grade threaded rod, mine is 9" long 9/16-12.
    Two extension (coupling) nuts are taper turned 3/4 of the 1"od. hex off.
    don

    [This message has been edited by don (edited 29 November 2003).]
    Last edited by ryan; 03-12-2019, 08:40 PM.

    Comment


    • #3
      Can someone please confirm the arbor dimensions in the above posting? Thanks you! Part# 95515-30
      Last edited by ryan; 03-22-2019, 07:44 PM.

      Comment

      Working...
      X