Tweet
The tab on the inside of the cap that I have does not reach the groove on the distributor. The ID of the cap has some play when fitted over the OD of the distributor. Only the two clips hold it in place. Wish someone would re-pop these caps like Indian does.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here