Tweet
My master cylinder cap was shot so I tried one from V-Twin. I like the quality. The hex is actually 1 1/8" not metric! Threaded in nicely. Nice machined aluminum cap in my opinion. Just thought I would pass on my purchase in case any one else needed one. Spring is here, flush the brakes!DSC06661.JPGDSC06662.JPGDSC06663.JPG
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here