Tweet
I am trying to resolve some wire pinching between my frame neck and steering head on my 62. I also have wires running between the seat mount along the top of my frame. Is this correct or should I go under the frame? It seems that there is not much room there but that is where they were when I first replaced them . I was wondering if anyone can give me an idea of how to run these wires so they dont get pinched.
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here