I have my 1956 Servicar rear end apart and need to change outer axle bearings. The 83160-51 thrust bushing sits between the rubber seal and the bearings. Is there any way to remove this bushing without destroying it? Thanks
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here